Blog
sustburbia.blogspot.com writes:
Back in July I was contacted by Nikki of fizzPop Hackspace in Birmingham about making very low cost Arduino clones on stripboard. I hadn’t really given it much thought until I realised how easy it would be to make an Arduino compatible device on stripboard (or breadboard) for something less than a fiver!
I’ve tried to standardise the design, to make use of the ATmega328 pin-out – which lends itself for an efficient layout.
Here’s a couple of recent boards – one is a controller for a spark ignition system, and the other is a general purpose layout – just the Arduino in the corner of a vast expanse of prototyping board.Below is the prototype spark ignition controller. It is based on the Atmel ATmega328 microcontroller and uses the standard FTDI USB to serial cable as a means of
Arduinoids – The Rise of the Machines - [Link]
Leave a Reply
You must be logged in to post a comment.