Blog
Bruce Heran writes:
This is a project that I always wanted to do, but managed to put off for a long time. It has been over a year in the doing. Partly because there are so many good phono preamps in existence and I was slightly concerned that it was beyond my design skills. It took over a year to get it up to my satisfaction. There were several iterations and lots of frustration along the way. My goal was to make a preamp that would not embarrass the builder with inferior performance. I used a number of commercial products for comparison. My thought was why bother to design and build something that was already available for a lower cost. As it turns out, it was not as inexpensive nor un-complicated as I first hoped.
The Groovewatt Tube (Valve) RIAA Phono Preamp Project - [Link]
Leave a Reply
You must be logged in to post a comment.