Home Blog  





26 Jun 2012

After a big response on the CL20M45 current limiting diode, we decided to add the type CL40M45 with a double nominal current. That´s why you´re free to choose from 2 types, and thus add a bigger variability to your LED applications.

In the article „Drive LEDs from 230V mains more simply and reliably“ we described to you the principle and usage of current limiting diodes (CLD) in detail. A new type in our offer – CL40M45 features a nominal current of up to 40 mA. Other specification is identical to the type CL20M45, especially Umax 45V and Ptot 1W.

By a simple replacement of CL20 for CL40 we can reach a significant change of a current flowing through LED diodes in the application. This can be convenient for example at designing a device with an adoptable power – at the production, it is possible to choose the type CL20M45 or CL40M45 – depending on customer´s requirements (higher light output or power saving at a lower light output). At the same time, this provides a possibility to reach a wide current range at parallel connection of various CLDs, without a need to modify the PCB.

As it is clear from the first sight, a higher maximum current through a CLD also means a higher heat generated on the chip itself. Both types feature max. power dissipation of 1W, that´s why it is necessary to take this fact into account at the circuit design. While at the CL20M45 it is possible to operate with the continuous current of 20mA up to a maximum operating voltage of 45V (P=0,02Ax45V=0,9W), at the CL40M45 the thermal loss (1,8W) would already be too high. That´s why the maximum continuous operating voltage on the CL40M45 is approx. 25V and the „reserve“ up to 45V is usable for elimination of spikes or disturbances in power supply and similar. For further increasing of durability and reliability, it can be useful to design a PCB with enlarged copper pads serving for trouble-free heat dissipation from the CLD.

LED diodes from the 230V mains on 2 ways - [Link]

28 Jan 2012

An SMD LED for direct drive with 120/230 V alternating current. The LED consists of two separate coils which are connected in parallel at 120 VAC, and in series for drive with 230 VAC. Available in cold white and warm white versions with a light flux of 360 lm and 280 lm respectively.

230V AC Powered LED - [Link]

20 Apr 2008

I needed a pulsating light for a certain signaling. Voltage was 230V. So I decided to make a simple circuit, consisted of a LED diode, two capacitors, two resistors, a diac and a diode.

230V Blinking LED - [Link]



 
 
 

 

 

 

Search Site | Advertising | Contact Us
Elektrotekno.com | Free Schematics Search Engine | Electronic Kits | Electronics Projects