Home Community

Xenon Strobe repair

Author Topic: Xenon Strobe repair  (Read 648 times)

animateme

  • Newbie
  • *
  • Posts: 1
    • View Profile
Xenon Strobe repair
« on: January 24, 2013, 04:26:56 PM »
Hello,
I have an old xenon strobe (disco light) that had been stored for a very long time and when I tried to turn it on recently, it no longer worked. I first assumed it was the xenon tube bulb so I replaced it but it still does not work.

I opened it up (circuit was inside wood box) to try and measure voltage at different points to see if I could determine any current interruptions but as soon as I plugged it in, there was a point on the back of the circuit that lighted up (burning) and even some smoke came out.  I immediately unplugged it.

Searching information on this I found this topic: http://www.aaroncake.net/Circuits/strobe2.asp , and it seems like my circuit is very similar.   The burning came from one of the terminals on what seems to be the 4KV Trigger Transformer (see red arrow on attached photos).

I am no electronics expert (I do own and can operate a multimeter), and that is where I would greatly appreciate any support on this forum, is there a way that I can troubleshoot this circuit to get it working again?   Any suggestions or ideas?   

Thanks on advance for any comments.


http://www.freeimagehosting.net/3t4m3


http://www.freeimagehosting.net/krfks


Electronics-Lab.com Community

Xenon Strobe repair
« on: January 24, 2013, 04:26:56 PM »