Make a Knight Rider bar

3
0

img_0015_400x300.jpg

Josh writes –

I’m making a Knight Rider (KITT) Light Bar to celebrate the premier of the new Knight Rider Made-For-TV Movie. I’m using an Arduino Diecimila board and 18 LEDs.

Materials (so far): FedEx box (temporary; looking for a suitable plastic container) with black construction paper for the housing. Arduino, 18 LEDs (wired to 9 output pins on the arduino – two LEDs in parallel per pin), 9 75 ohm resistors (note, 75 is not the right value, but they were the closest I had). The faceplate is made of cardboard, tissue paper (light diffusion) and some cheap car-window-sun-shade-material I found at Target. [via]

Make a Knight Rider bar – [Link]

Leave a Reply

Your email address will not be published. Required fields are marked *