Tag Archives: PT2262

4 channel RS485 Remote Controller

4 Channel 2 core twisted pair remote controller built using PT2262, PT2272-M4 IC from Princeton technology and MAX485 IC from Maxim. PT2262 is an Encoder (Transmitter), PT2272-M4 Decoder (Receiver) and MAX485 works as bridge for twisted pair communication between encoder and decoder. The receiver provides 4 channel Momentary outputs. All outputs are TTL level and can be interfaced with other circuits or relay board. Transmitter works with 5V to 12V DC. Receiver works with 5V DC.

When any of SW1-SW4 (S1-S4) tact switches is pressed, power is applied to encoder IC and RS485 IC, the encoder starts scanning Jumper J1-J8 and transmitting the status of the 8 bits address and data serially. The decoder IC receives the data from MAX485 and compares it two times with J1-J8 address jumpers, also provides outputs high and at same time VT (Valid Transmission) LED goes On, if the data is Valid and address of Transmitter and Receiver are same. It is important to have same jumper settings J1-J8 at transmitter and receiver to pair both.

4 channel RS485 Remote Controller – [Link]

4 Channel RF Remote Controller

4-Channel-RF-Remote-Controller-001

4 Channel RF remote built using PT2262 and PT2272-M4 IC from Princeton technology. PT2262 used as Encoder (Transmitter) and PT2272-M4 Decoder (Receiver) ICs are heart of the project. The receiver provides 4 channel Momentary outputs. All outputs are TTL level can be interface with other circuits or relay board. Transmitter works with 5V to 12V DC. Receiver works with 5V DC.

Features

  • Wide Range of Operation Voltage 5V to 12V Transmitter
  • Supply 5V DC Receiver
  • On Board Data Transmission LED
  • Single Resistor Oscillator
  • 4 Momentary Outputs
  • 4 Outputs TTL Level
  • Address setting 3 states HIGH, LOW, And FLOATING)
  • Remote provides 6561 addressable combinations by setting up J1-J8 to High, Low, and Floating.
  • On Board Power and Valid Transmission LEDS Receiver
  • ASK Modulation
  • RF link work on 433.92 MHz Frequency
  • CMOS Technology
  • Low Power Consumption
  • Very High Noise Immunity
  • Up to 8 Tri-State Code Address Pins
  • PCB Dimensions Transmitter 36MM X 26.67MM
  • PCB Dimensions Receiver 45.40 MM X 26.67

4 Channel RF Remote Controller – [Link]