[0-30 Vdc Stabilized Power Supply]

I made the circuit as it is on the web.
The thing is, that there was no reading of the ampmeter ( i have not reading of the ampmeter before ) when the power source came down, but the led wasn´t on when it happened.

The load was a stepper motor of 1.4 amps per phase and  5 v, connected by a tanslator circuit of TIP120 transistors (that the have a protection diode), that were controlled via a circuit with the parallel port.(all conections were ok)

I think that the problem has to be with Q1 as it is alreay on ,and i read a 45v betwen the colector and the emiter ,probably in the saturation region.

I dont know if Q1 has burn out or just the negative rail is still at the the level of the shut down protecction circuit.

Thanks for your support.

[0-30 Vdc Stabilized Power Supply]

Hi , i have built the power supply and for several try it has worked but ( it has never show me current at the ampmete rconnected in series with the positive wire) when i loaded  suddenly, i  just can read  0 v in voltmeter output.
I dont know if it has to do with Q1 ant the shutdown protection or just Q1 has blown off.
Any idea?
Thanxs