Jump to content
Electronics-Lab.com Community

gughanath

Members
  • Posts

    25
  • Joined

  • Last visited

    Never

Posts posted by gughanath

  1. hehe, no you explained it well :). I am not an electronic genius, but you definitly are, you just saved my life. Thanks a loooooooooooooooooooooooooooooooooooooooot!! ;D

  2. I have a vibration sensing alarm circuit here. I want to build in a switch, which should act like a reset switch. It should stop the buzzer from sounding, the LED from emitting light and decharge the capacitor. I tried many time but couldnt find the right place to place the switch. The fist swtch on the right is the main switch, the push to make switch is the vobration switch. By the way, it has got to be a standard SPST on/off switch. Please help, urgently needed!
    %7Boption%7D

  3. :-\I have made a case for my bike alarm out of ABS. I have drilled holes to allow sound from the buzzer to come out. Now, the problem is, if it rains, my alarm will get damaged because the water would flow through the holes into the circuit. The ABS is waterproof already, but how can I prevent the water going into the circuit without blocking the sound from the buzzer? ??? ???

  4. This is a simple potential divider...The battery supply is 12V...The voltage accross the 200 ohm resistor is 8V...and the voltage across the 100 ohm resistor is 4V...shouldnt the resistor with the greater resistance have the lower Voltage...i dont undertand this?...please help

    post-5539-14279141974785_thumb.jpg

  5. basically a vibration switch is like a tilt switch, it has two pins and a mercury ball. The ball sits on top of one pin, when the switch is tilted (by a very small angle), the ball makes contact with both pins, completing the circuit. I asked my teacher and said that a vibration switch does act like a push to make switch. Thanks alot for your help, your circuit helped me progess with my project. Thank you!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! :) :) :) :) ;D ;D ;D ;D!

  6. hey,,,,thank you very much for da circuit...but there still is a problem...when I trigger the tilt switch, the alarm does reset itself after a while, but then it starts again for some reason? How do I solve this problem?by the way, in my circuit simulation, I am using the tilt switch as a normal on/off switch.

  7. Hey..sorry the circuit above is messed up...da correct circuit is attached to this message...i cant replace the push-to-make switch with a tilt switch (which basically acts like a normal switch on/off) because when the tilt switch makes contact and complets the circuit, it needs to break contact as soon as possible, so the automatic reset can happen. If the switch does not break contact, the automatc reset will not happen.
    My teacher said that I have to use another 555 Timer to send a pusle to the switch to turn it off. How can i do that????.%7Boption%7D

    post-5539-14279141959426_thumb.jpg

  8. hey everone....i have a circuit here....i need to know how to replace the push-to-make-switch with a tilt switch, so I could use this circuit as a bike alarm??....please help...i really need HELP!!!!!!!!
    Please download the picture of the circuit attached to this message, look at the circuit and please reply me at [email protected] if you know how to solve my probelm. Thx.

    post-5539-1427914195926_thumb.jpg

×
  • Create New...