I want to design a 4-bit unsigned binary multiplier. This circuit should be accepting two 4-bit numbers and compute an 8-bit product. The result is to be displayed on two 7-segment display units. The multiplier should be started with a RESET signal. A READY output is to indicate the end of the operation. I want to use three registers (74ls194) and one 4-bit full adder (74ls283) for the circuit, but I'm little confused about the control unit I wanted to use TTL only, but any idea is welcomed. All my ideas are too long and I was wondering if anyone know easiest way around. I don't mind using any components 8) 8) 8)