Jump to content
Electronics-Lab.com Community

Stockleys

Members
  • Posts

    2
  • Joined

  • Last visited

Posts posted by Stockleys

  1. I got myself a usb scope.   

    I found that the egs002 wasn’t giving the correct wave.  On outputs 1 and 2.   And output 3 was a constant 6v.  Not a wave at all.    Got another egs002 (before getting the scope). And that had one dead output.

    Attatched is a schematic for the egs002.   And the h bridge.  Which although not for my inverter, is identical   

    B0526E47-0F63-4D0C-ADDB-2D90FFD0D2DC.png

    D4ACCA77-2189-407E-8F6E-F66AA88AE8DD.png

  2. Hi all. 
    First time post for me
    I’m after some help
    I am trying to repair a high frequency 3000w inverter.
    It worked great for 3 weeks when I got it (after replacing 2 IGBT’s)
    But then they blew and many more replacements

    I bought a new spwm board from the manufacturer and a complete new set of IGBT’s along with their associated resistors and diode.

    Installed. And nothing. ABout 10 seconds in and one of the h bridge drivers exploded.

    So I ordered an EGS002 board from amazon. All pinouts exactly the same. Same chips as the spwm from the manufacturer only a third the price.

    I have installed this and tested all components around it including the IGBT’s. They are all good.

    The IGBT’s are getting a steady 390vdc source. 
    The spwm getting a steady 5v and 12v
    But I can’t get an output. I can hear the transformers buzz for 3 seconds then stop I get a blip of up to 8vac at the output. 

    The spwm board flashes out the code for under voltage and over voltage. 

    Where do I go from here? I don’t own a scope. Only a ddm. 

    I have checked and re check all components and solder joints.  But as I don’t own a scope, I can’t think what else to do.
    Thanks in advance

×
  • Create New...