Jump to content
Electronics-Lab.com Community

Recommended Posts

A digital voltmeter has to convert the voltage of the signal to a binary represention for digital readout. This requires an A/D. So a dual ramp A/D uses one ramp that takes the voltage higher and another ramp which lowers the voltage. This is how you create a time difference, by taking the voltage higher then low. A counter then counts the time back to the low voltage. How high the voltage of the signal is determines how high the ramp will take it. The negative ramp pulls the voltage past down the reference voltage. This is how it works.

Link to post
Share on other sites

There is very little difference between the dual slope and the single slope. Both methods are good and even the single slope requires two ramps. I chose a project with the dual slope because I could set the reference voltage at ground potential. It is not often hard to conceptualize the problems with setting a reference voltage. Whenever you have a regulated reference voltage your okay. If you must set the reference through a resistor it will change with the current thus creating a signal. So I would prefer the solid ground as my reference.

Link to post
Share on other sites
  • 11 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
  • Create New...