Jump to content
Electronics-Lab.com Community

transistor voltage regulator


walid
 Share

Recommended Posts

Hi Walid,
You can't make a voltage regulator without a voltage reference like a zener diode or a voltage divided from a stable reference voltage. Since you are using a PNP transistor, input and output voltages in my descriptions are negative:
1) If the 10V is stable, then the 2N5401 can be used as an emitter-follower voltage reducer with the 10V divided down to about 8.2V with a couple of resistors. Since you need 1.8V across one resistor and 8.2V across the other, their ratio must be 1.8:8.2. Use 1.8k and 8.2k. With a lw load current, the emitter's voltage will be about 7.5V.
2) You can use the reverse-biased base-emitter junction of a silicon transistor as a 6V to 7V zener diode when it has avalanche breakdown. If the voltage is too low, the transistor's forward-biased base-collector diode can be added in series with it for about 0.7V more. A forward-biased silicon diode can also be added in series for about 0.7V more. Like a zener diode, the current must be limited with a resistor in series. ;D

Link to comment
Share on other sites

  • 2 weeks later...

Something worth noting about regulators. I have this idea that major power supply manufacturers subscribe to this idea. If for every current you can maintain the same voltage, you are a winner. I have often wondered how you can purchase a supply and be guaranteed of the voltage at virtually any current. This is definitely an engineering marvel. Virtually no switches or ranges that are found on multimeters.

Link to comment
Share on other sites

Hi Kevin,
A linear voltage regulator has a reference voltage generated by a temperature-stable zener diode or band-gap device that is amplified and buffered from its load by a high input resistance opamp. The opamp drives a series pass power transistor that is in series with the load and operates like a variable resistance. The opamp uses its extremely high gain to compare the output voltage with its reference voltage and adjusts the output voltage to be the same. ;D 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
  • Create New...