Jump to content
Electronics-Lab.com Community

3dB point or pole


walid

Recommended Posts


Hi Walid,
A 3 dB point is the frequency that the stage's output is down -3dB from the output at much lower frequencies.
-3dB is half power or 0.707 times the voltage.

A pole is an RC lowpass filter caused by the "Miller capacitor" of a transistor's collector-base capacitance.

Opamps have a dominant pole at a low frequency with a capacitor placed on purpose, to avoid phase-shift from other higher-frequency poles which would cause oscillation.
The -3dB point for an old uA741 opamp is at only about 25Hz. Modern opamps have it at 200Hz or higher.

post-1706-14279142317379_thumb.png

Link to comment
Share on other sites

What I normally use is db = 20logVout/Vin. Since you are dealing with a capacitor, you might as well use peak to peak voltage. You will notice that you could use the instantaneous voltage, the results are the same, but you should not because there are many instances where the instaneous voltage does not divide.

So, what you are looking for is the frequency at which your output voltage is %70.7 of your input voltage. In this case, you can use peak to peak or instantaneous. Plug in a frequency to your simple RC filter, output referenced to ground, check that your voltage is % 70.7 your input voltage.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
  • Create New...