focusritetech Posted January 21, 2006 Report Share Posted January 21, 2006 I have power supplies built in England for a analog console and losing transformers, output to main caps burning up!! What do I measure for output volts? Should it be under load while finding voltage output? I get no info from Duvine in England because it is 13 years old and the specs are buried deep. Anyone wanna help?? Quote Link to comment Share on other sites More sharing options...
ante Posted January 21, 2006 Report Share Posted January 21, 2006 Hi Eric,Welcome to our forum.The caps should have a voltage rating higher than the voltage without load. Quote Link to comment Share on other sites More sharing options...
MP Posted January 27, 2006 Report Share Posted January 27, 2006 Does it have a schematic inside it? That is the one thing I really liked about the older equipment. They almost always glued a schematic inside the box so you could fix it someday.If you have one, you could scan it in. A forum member might be able to tell you where to check for voltages, what looks like a weak link, etc.MP Quote Link to comment Share on other sites More sharing options...
Soldertraining Posted June 23, 2017 Report Share Posted June 23, 2017 Transformers pass alternating current and normally are used to step up or step down voltage. The reason to change or replace the transformer is to fix damaged that can be caused by gross under loading and impedance mis-matching, among other things. Transformers can carry dangerous levels of electrical power, so be careful while replacing the transformers, it may cause serious injury or even death. The replacement transformer must be a low-voltage dry-type, meeting or exceeding the TP-1 efficiency standard. The rated size (kVA) of the replacement transformer must be equal to or less than the existing transformer replaced. Quote Link to comment Share on other sites More sharing options...
Elex518 Posted February 3, 2019 Report Share Posted February 3, 2019 No need to add load when measuring transformer output. I suggest you check that power supply capacity in Voltage DC and Current. The find a replacement, so many now in the market with cheapest prices. But you should have a good background in electronics. Check here for more repair tips --> https://elex518.blogspot.com/ Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.