Guest Zeppelin Posted April 9, 2006 Report Share Posted April 9, 2006 I have been using Orcad 9.2 for some time now & I know how to set up transient, DC sweep & AC sweep simulations; but there is one thing I can't figure out: How can I setup an analysis based on a variable resistor, capacitor, etc? Any ideas? Quote Link to comment Share on other sites More sharing options...
Godfather Posted April 9, 2006 Report Share Posted April 9, 2006 Hi,From what I'v know you can't. I simply put a resistor/capacitor,change the value and simulate again. Quote Link to comment Share on other sites More sharing options...
scuzz Posted May 30, 2006 Report Share Posted May 30, 2006 You should try analise Monte Carlo / Worst Case, but I'm not sure is this what you raely want. Quote Link to comment Share on other sites More sharing options...
r08ert.w Posted September 3, 2006 Report Share Posted September 3, 2006 That's right Zepplin, for those of you who haven't figured it out yet, it's using the PARAM object found in the SPECIAL.OLB library. There are many tutorials out there which tell you how to configure the values in this object. Quote Link to comment Share on other sites More sharing options...
login
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.