wuemura Posted July 29, 2006 Report Share Posted July 29, 2006 The good thing is, it works very wellhttp://myweb.cableone.net/wheedal/pcb.htm Quote Link to comment Share on other sites More sharing options...
wuemura Posted July 30, 2006 Author Report Share Posted July 30, 2006 I've done this today, it works fine, it took me about 30 min to make the board. The pages that i use do not absorve the toner, you can remove from the pages with your fingers if you want to. The transfer process took about 5 minutes, very fast and clean. Quote Link to comment Share on other sites More sharing options...
ante Posted July 30, 2006 Report Share Posted July 30, 2006 Thanks, looks great I’m going to try it! ;) Quote Link to comment Share on other sites More sharing options...
gogo2520 Posted July 31, 2006 Report Share Posted July 31, 2006 Hello I do this all the time, except I use a cloths Iron instead of a transfer thingy. Wooks good. Also I use regular office gloss paper, its just like magizne paper and I don't have to worry about recking my printer. have fun gogo Quote Link to comment Share on other sites More sharing options...
wuemura Posted July 31, 2006 Author Report Share Posted July 31, 2006 I did my board with cloths Iron also, it took about 2 min to transfer the toner, and like the photos in that link, the design came out perfet. Quote Link to comment Share on other sites More sharing options...
gogo2520 Posted August 3, 2006 Report Share Posted August 3, 2006 Hello Either way, some people swear by photo paper. I tried it, it takes forever to soak the paper off. mag paper all most falls of when it hits the water. What I would like to learn more about is coatings. have fun gogo Quote Link to comment Share on other sites More sharing options...
wuemura Posted August 3, 2006 Author Report Share Posted August 3, 2006 Yes, the process is very easy, here some photos of my board, so easy and you dont have to try "x" times, just put the board under water and it's done, can't be more easy than this, and is very cheap. Quote Link to comment Share on other sites More sharing options...
crodan85 Posted August 9, 2006 Report Share Posted August 9, 2006 Tried PnP with some luck also tried glossy photo paper it worked the first time after that I couldn't get the same results. So might as well give this a try. :) Quote Link to comment Share on other sites More sharing options...
wuemura Posted August 30, 2006 Author Report Share Posted August 30, 2006 Hello!I've done a few more boards using this magazine paper, and it works like a charm. I think i've about 30 or 40 boards every and each one perfect.Also works fine to make component map. Quote Link to comment Share on other sites More sharing options...
ben11 Posted September 2, 2006 Report Share Posted September 2, 2006 i went to your web site and read but i did not understand everthing so i will ask you some questions (if you do not mind). do you have to use the magazin paper as printer paper? Quote Link to comment Share on other sites More sharing options...
wuemura Posted September 2, 2006 Author Report Share Posted September 2, 2006 i went to your web site and read but i did not understand everthing so i will ask you some questions (if you do not mind). do you have to use the magazin paper as printer paper?Sorry but that is not my page ;)Yes, i do use magazine paper in my printer, just cut the paper and glue or put some tape to fixate the page OVER the normal A4 printer paper. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.