Jump to content
Electronics-Lab.com Community

dBm to Vrms


RF Burns

Recommended Posts

Dear all,
              I generated a 50 MHz, -10 dBm sine-wave using a Rhode & Schwarts RF signal generator.  I checked this using an Agilent spectrum analyser and, as you'd expect, I get my tone at 50 MHz with peak amplitude of -10 dBm.  However, when I input my RF signal to a TDS 210 Tecktronix Digital Oscilloscope, the peak-to-peak voltage is 336 mV and the Cyc RMS voltage is 117 mV.  Now, on the TDS210, Cyc RMS calculates the RMS voltage over one complete cycle of the waveform. 

When I tried to calculate this I got a different answer:

P = -10 dBm, which is equivalent to 100 uW
Now, P = V^2 / R 
I've taken R = 50 ohms
Therefore Vrms = sqrt(P x R)

That is: Vrms = sqrt(100 uW x 50 ohms)

So, Vrms = 70.7 mV 

This is different to the 117 mV measured on the oscilloscope??

Link to comment
Share on other sites


Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
  • Create New...