vivek_pv Posted February 15, 2007 Report Share Posted February 15, 2007 Dears,I need to construct an amplifier for the Shure SM58 mic.The impedance is 150 ohms.Please help.Regards,V Quote Link to comment Share on other sites More sharing options...
audioguru Posted February 15, 2007 Report Share Posted February 15, 2007 Hi Vivek,I haven't seen a preamp circuit for a dynamic mic for many years. I use electret mics now.Look for Dynamic Microphone Preamp Circuit in Google. There are many circuits, some are good and many are horrible. Quote Link to comment Share on other sites More sharing options...
vivek_pv Posted February 15, 2007 Author Report Share Posted February 15, 2007 Thanks Audioguru.But this mic has 3 pins. What are those? The circuits I saw were the ose with 2-pin inputs.Please help. Quote Link to comment Share on other sites More sharing options...
audioguru Posted February 15, 2007 Report Share Posted February 15, 2007 Look at XLR Connector in Google. It shows the balanced signal pins and the ground pin of your microphone. Shure's datasheet for your microphone also shows which pin is which.Most of the "horrible" schematics of preamps with only two wires for the mic are for cheap toys. Your Shure professional microphone is not used in toys, it is balanced. Quote Link to comment Share on other sites More sharing options...
vivek_pv Posted February 17, 2007 Author Report Share Posted February 17, 2007 I got some information on XLR pin mics.I think there is one "Normal polarity" and another "inverted Polarity"Should I use these like: normal to "non-inverting" and inverted to "inverting" ends of an OP amp?Regards,V Quote Link to comment Share on other sites More sharing options...
audioguru Posted February 17, 2007 Report Share Posted February 17, 2007 You cannot connect anything directly to both inputs of an opamp because the voltage gain would be 200,000 at low frequencies which is way too high. The opamp needs to have negative feedback to reduce the gain to a usable amount. The inputs of an opamp also need to be biased correctly.Look in Google for Opamp Differential Input Pre-amplifier Circuit that has two inputs for a balanced microphone. Quote Link to comment Share on other sites More sharing options...
MP Posted February 25, 2007 Report Share Posted February 25, 2007 Vivek,The Shure SM58 provides a positive signal on pin 2 with respect to pin 3 when pressure is put on the diaphragm (when sound hits it). Pin 1 is connected to ground. To connect this microphone to an unbalanced mixer, you just connect pins 3 and 1 to ground and use pin 2 as your signal output. This is all you have when you purchase a cable with XLR on one end and 1/4" phono jack on the other end.You will not see any difference in the output unless you are running massive lengths of microphone cables.MP Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.