Jump to content
Electronics-Lab.com Community

Salt-taster


walid

Recommended Posts

Hi
I built this circuit on a test board
http://www.redcircuits.com/Page68.htm
SaltTaster.GIF
the sensing leads are simply two thin copper wires
i connect these two leads together, this equivalent to a very low resistive solution.
when operate the circuit, the red led (D3) is on and the other green and yellow are OFF
when trying to adjust the variable resistor R4, it has no effect at all
i check the connections many times, they are OK.
I understand the three comparators operation
and know that the two red leds D1 & D2 are a voltage references as the writer said
also i know that the first op amp (IC1A) is function like this:
diffamp.jpg
and this:
diffamp2.jpg
I use a 10.5V power supply
I measure pin1 voltage = 9.1V where pin5 = 4.3v
i try to make pin1 voltage lower than pin5 but can't
please help me in fixing the broblem
thanks

Link to comment
Share on other sites

  • 2 weeks later...

Now I have a Specific question which is:
comparing the folloing figure:
diffamp2.jpg
with this figure (salt0001):
salt0001.jpg
Noting that the voltage at pin 1 (Vo) = (e2-e1)(R2/R1)
I note that e1 = 1.8 V
e2 must be Slightly lower than e1, say e2 = 1.7V
so Vo = (1.7-1.8)(220K/10K) = - 2.2 V
If the solution resistance is increased, then e2 will be lower, say, 1.5 V
so Vo = (1.5-1.8)(220K/10K) = - 6.6 V
In all cases the o/p Vo will = 0 V because we supply LM324 with a single power supply.

Either the equation (Vo) = (e2-e1)(R2/R1) is wrong and must be (Vo) = (e1-e2)(R2/R1)
Or the design is wrong?????

Link to comment
Share on other sites

Hi
I feel I am alone with this question.
But in any case, I built the circuit and worked excellently.
The question remains puzzled me is the importance of R1 (=470 ohm)
when i tried to remove it, the red led is illuminate
It remains as to whether or not there is a salt solution
can anyone explain to me the function of this R1
thanks 

Link to comment
Share on other sites

Hi Walid,
It takes a higher current to develop voltage across 470 ohms than it does if R1 is removed and instead 230k is there. Without R1 then the circuit would detect a very weak salt solution.

Without R1, the first opamp would amplify the voltage developed across the 220k resistor caused by the opamp's input current.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
  • Create New...