Shakirel Posted May 3, 2007 Report Share Posted May 3, 2007 I want to use these drivers for an H bridge but havent figured how to properly connect them so that they work.Here is the part of the schematic that includes them:As this,when i put all of this on a test board it does not move a bit.The upper mosfets should switch at 50Hz and the bottom ones at 8MHz.The upper part of the H bridge ~350V This is part of an inverter.Thanks a lot for any advice. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.