Jump to content
Electronics-Lab.com Community
Sign in to follow this  
walid

question about Low Pass Filter

Recommended Posts

The 4.7nF capacitor creates a lowpass filter with the unknown value of the source resistance.
The 10k resistor and 6.8nF capacitor create another lowpass filter.

If the cutoff frequency of both filters is the same then their total is -6dB because each filter is -3dB.

Share this post


Link to post
Share on other sites

The 4.7nF capacitor creates a lowpass filter with the unknown value of the source resistance.
The 10k resistor and 6.8nF capacitor create another lowpass filter.

If the cutoff frequency of both filters is the same then their total is -6dB because each filter is -3dB.


If the cutoff frequency of both filters is  not the same? is it sitll -6dB
thanks

Share this post


Link to post
Share on other sites


If the cutoff frequency of both filters is  not the same is it sitll -6dB?

No.
You need to calculate the amount of attenuation. One filter might pass the cutoff frequency of the other filter then the attenuation is only -3dB.

Share this post


Link to post
Share on other sites

Phase shift oscillators produce 180 degrees phase shift using cascaded RC stages. Maybe the components are chosen so that each stage is independent of the other and reduces the loading effect, which would keep the phase shift at 90 degrees at best.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...