Jump to content
Electronics-Lab.com Community

24V to 5V 150A


nissim69

Recommended Posts


I have TI design with Two-Phase Synchronous Buck Controller w/Integrated Mosfet Drivers.
base on TPS40131 (http://focus.ti.com/docs/prod/folders/print/tps40131.html)

.... so if I will keep the same design, and just add more power Mosfet in parallel and keep the same coil value micro hanrey, just make it not saturate in 150A all will work ?

Link to comment
Share on other sites

The V in is 24 Volt from bus batteries.
Every module, has also logic control , so all has reference to GND. meaning I need to send set Pixel command from digital card that has GND and 5V supply.

So to cascade all module is will not work. every module will have floating GND. and will not get digital command on his bus.

If there is some low cost switching power supply 24 V to 5V 4 A, with cost 1 to 1.5  USD. I can put that power supply near every module. But I do not think I can find that solution.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
  • Create New...