XBEE CONFIGURATION

[amlovingyou]

I couldn't configure the XBee modules.
details given below, anyone pls help...

Transmitter:

Restore default parameters: ATRE
Set transmitter destination address: ATDL = 0x1234
Set transmitter source address: ATMY = 0x5678
Set D0 as analog input: ATD0 = 2
Set D1 as analog input: ATD1 = 2
Set D2 as analog input: ATD2 = 2
Set D3 as digital input: ATD3 = 3
Set D4 as digital input: ATD4 = 3
Enable pull up on digital inputs D3 and D4: ATPR = 0x03
Set sample rate to 100ms: ATIR = 0x64
Write parameters to non-volatile memory: ATWR

Receiver:

Restore default parameters: ATRE
Set receiver destination address: ATDL = 0x5678
Set receiver source address: ATMY = 0x1234
Set receiver input address: ATIA = 0x5678
Enable uart output: ATIU = 1
Set P0 in order to drive the RSSI LED according to signal strength: ATP0 = 1
Write parameters to non-volatile memory: ATWR