Jump to content
Electronics-Lab.com Community

Dual Trace Oscilloscope Input


Dreamdrifter

Recommended Posts

The sample, calibration square wave of an old oscilloscope is operational, but shows spikes and reduced amplitude. I suspect that the input resistor is fried. I seem to remember the standard impedance was 1 Meg ohm and that the ersistor is in parallel with a capacitor. Any chance someone will sahke my memory and tell me the the general value? IT has been 20 years and I need more than just a pair of new glasses to go behind the case screw. Trace "A" works fine. I am not too lazy to look, just want to know if the symtoms put me in the ballpark. Thanks! I'm new here so please forgive my lack of 'smarts.'

Link to comment
Share on other sites


Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
  • Create New...