Jump to content
Electronics-Lab.com Community

UPS MGE PULSAR ESV 22+


HackoBoy

Recommended Posts

Hello

I have this UPS - without battery pack and external cabble with 9 pin molex mlx.

I need the circuit to know how to connect the batteries. Because with this connector I have cables from the battery (I suppose is for 48 volts) I have the power cables to the transistor switches but I have 2 cables that go to the electronics that drives the power part.

Link to comment
Share on other sites


no.
In this file ( who i downloaded  before days ) i do not see how this 8 x 6 V Batteryes  will be conected with cable and 9 pin connector . .
In my case i have 9 wire on this connector . 
3 from them - connected  to Positive end from Battery pack 
3 from them - connected  to Minus from Battery  pack.
This wire connected to power inverter MOS Transistors 

1 wire - connected  to chassis of UPS
Have 2 wire - who connected to pcb up to  transistors , resistors , diodes , CPU ) 

 

It is possible with these two wires to feed the electronics that command the mos transistors and do not know what voltage it should be.
That's why I was hoping for this scheme - to see at certain points what I should have

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
  • Create New...