Jump to content
Electronics-Lab.com Community

Need help with using a transistor or triac as a switch


MAJ
 Share

Recommended Posts

Hello everyone,

I have a digital programmable timer with signal output of 1.2V DC. It runs on rechargeable battery of 1.2V. I need to use this small output to run a small 6V relay. To my general knowledge, I need at least 3 volts to trigger a small transistor. Is there a transistor that can be triggered by 1.2V signal? or can I use a photoisolator triac to drive the relay with the small 1.2V signal? Thanks.

Link to comment
Share on other sites

Same question again but on this forum.

Here you forgot to say which relay you will use so we do not know its coil current then we cannot calculate how much input current a transistor needs.

You also did not say how much current the 1.2V timer can produce which might not be enough current to drive the transistor.

1.2V is probably too low to activate a photo-triac.

Link to comment
Share on other sites

Hello Audioguru, and thanks for your reply. Attached is the data sheet of the relay I have. The model is SRD-06VDC-SL-C. I do not know how much current the timer can provide. I hope there is a way/component that can be triggered by the 1.2V output. Otherwise, I will have to buy a new timer, but I am really interested to get the timer I have to work, of course if possible.

Relay.png

Link to comment
Share on other sites

Lets see if this is readable. Using a 2n2222 - about 10 cents apiece. Current from the source is 40ma with a base resistor of 1000 or 10k.

In the view the yellow trace is the current through the relay; scale on the right . Green is the voltage at the base9444813_relaydriver.png.6edeb2743afb8a53b3e42f556afb4767.png; scale on the left. I  have no idea what the inductance would be so I set it at 0.001 henry.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
  • Create New...