This Phoneix programmer is based on the version previous released by Odin.

Joos Design have added a better power supply and made some other small changes.

We presume a Phoenix programmer will not be your first build, so a detailed instruction is not supplied.

The PCB drawing shuld be downscaled to about 12 % of the original,

make a test printout and verify you have the right distance for the IC legs.

Download in zip

PART LIST FOR PHOENIX PROGRAMMER

Reference to Component.bmp

POS NO SPEC. RS PART NO.

__________________________________________________________

1 Main board

2 Smart Card Connector 197-1197

3 9 Way D connector - socket 446-585

4 Fastening Screws

5 DC Power Connector 486-662

6 Heat Sink - only needed for heavily use L=19mm W=13mm

7 5V Regulator 853-371

8 Fastening Screw

9 Bridge Rectifier 657-088

10 Resistor 20K ohm 163-763

11 Resistor 220 ohm 149-650

12 Resistor 220 ohm 149-650

13 Resistor 220 ohm 149-650

14 Resistor 2K2 ohm 149-739

15 Resistor 1M ohm 149-975

16 Not used

17 Crystal 3.579 MHz 226-1500

18 Capacitor 1 uF 200-6167

19 Capacitor 0.1 uF 115-988

20 Capacitor 0.33 uF 116-032

21 Capacitor 100 pF 128-168

22 Capacitor 27 pF 128-763

23 Capacitor 27 pF 128-763

24 Capacitor 33 uF - only needed for heavy use 116-880

25 LED green 590-345

26 LED red 590-339

27 IC 7407N 306-336

27b IC socket 14 pin 447-314

28 IC MAX232ECPE 225-8510

28b IC socket 16 pin 447-320

29 IC 74HC04N 217-5550

29b IC socket 14 pin 447-314

30 Secondary board, on top of smartcard connector.

Mount everything but the secondary board, leds and ICs

Mount top of leds into the secondary board, fasten secondary board to top of smartcard connector

after carefully first having put the led legs through the holes in main board.

Finally , ground yourselves to get rid of any statics and mount the ICs.