crutschow
- Joined
- Last seen
- Messages
- 991
- Reaction score
- 395
Latest activity Postings About
-
-
crutschow replied to the thread Two audio outputs into one 8 ohm speaker.Just make sure the two transceiver speaker grounds have no significant potential between them when both are on. The resistor isolation... -
crutschow replied to the thread Two audio outputs into one 8 ohm speaker.So how will you now which is generating the sound when both are on? Is there a visual indication?
-
crutschow replied to the thread Two audio outputs into one 8 ohm speaker.Does either of the tranceivers have an output indicating that they are on? If so, you might be able to use that to operate a relay that...
-
crutschow replied to the thread Two audio outputs into one 8 ohm speaker.You could also use a dual voice coil speaker, although they tend to be a little expensive.
-
crutschow replied to the thread AI Data Centres.I consider AI with their large data centers to be (or soon to be) a pox on this planet. Already some of the AI models have run amuck...
-
crutschow replied to the thread How is coating wear on ESD tweezers typically assessed in production environments?.What is the purpose of this "anti-static" coating on the tweezers since they are made of conductive metal? Does the lack of it affect...
-
crutschow replied to the thread Found problem in Kenwood KR-V95R.Hopefully. But the OP hasn't been seen here since 2020.
-
crutschow replied to the thread Latching relays in a control circuit.My question was whether you could wire and solder the parts on a vector board if given the circuit schematic and the parts required?
-
crutschow replied to the thread Latching relays in a control circuit.It can be done with some simple logic circuits if you are up to building that. What are the relay-coil voltage and current requirements?
-
-
Loading…
-
Loading…