Hello,
The datasheet i posted shows wich pin is positive and wich pins are negative.
Even an axial capacitor would be possible to use.
The positive can go through the pcb and the negative lead can be extended by soldering a wire to it and put the wire in the negative connection hole.
Bertus
Hello,
In germany there is a site called askjanfirst.
There is an alternative for the capacitor there.
On this page about capacitors, there is an 220 uF 450 Volts capacitor:
https://www.die-wuestens.de/dindex.htm?/k1.htm
Look for code KON22145 on the page.
Bertus
Hello,
With 2.2 volts there is a possibility that the mosfet will not turn on, as the gate threshold is between 2 and 4 volts for the irzf44.
An irlz44 will likely have more success.
Bertus
Is the orientation of the magnets (north / south) correct?
Is the polarity of the coils correct (is one of the coils the wrong way around)?
Did you try to hold the hallsensor the other way around?
Bertus
Hello,
Have a look at a circuit created by danko on AAC:
https://forum.allaboutcircuits.com/threads/trying-to-make-a-moped-ignition-coil-tester.210360/#post-2033847
Timing might be adjusted for longer times between pulses.
Bertus