shrtnd,
All this stuff is made in China. Difficult to really get any technical help. I did email them however and actually got a response but all they did was give me a link to the 12-24v unit on Amazon.
We are remodeling our home and I have decided to make it a 100% LED operation. I have installed "under the counter" 12 VDC LED light strips in the kitchen, triggered by a motion detector and incorporated an "Oznium" "Fade in - Fade out" dimmer. Works great. Now I want to include a large (18" x...
Gryd3,
Thanks for the reply and advice. In the event, it was much simpler than I thought it might be after I took my first look at the board (see attachment). I realized that all I really needed to do was determine what the (5) pins that 'come' from the socket are for. It was easy enough to...
I have recently configured my entertainment center with wired headphones plugged into a (wired) remote amplifier with separate volume controls. It plugs in to my Denon A/V receiver.
Everything works great except when we want to listen to the surround speakers system we have to get up, go over...
Steve, Thanks for the tip. Worked out just like you said. I have done a little bit of this kind of soldering before but never any desoldering. Being a bit ham fisted with these more delicate operations I didn't have a lot of confidence I could do it. Was easier than I thought. On to the next step!
I am firing up a little project that requires the relocation of a red-blue-green LED and a slide switch. The slide switch as shown (upper two images) is actually 3 positions but functionally only the left and right positions are used. (I don't know why the mfgr used a 3 position switch).
I...
Well, I am not sure why I didn't get even one response but I did solve the problem...
Rather than include a switch to manually drive the system (east or west) I found that the "sun threshold voltage divider" 9.1k resistor is what determines the sensor sensitivity. So I played around with...
Hello,
I just registered and this is my first post. I have recently embarked on a project to mfgr a portable solar tracker to use when we go camping. I purchased and assembled an MTM solar tracker board and basically have everything working (in its "test" form).
Witness this post... I am just...