Hmm I see now. So the brake light switch needs to run through the turn signal switch. That's starting to make since. Is there a way to figure out what wires I need to connect with my meter? Or do I just need to get a wireing diagram?
I have it set up to we're there is 2 studs on the firewall I'm connecting everything electrical to them. Ones positive and ones ground. They both have cables going directly to the battery. I'm almost positive it's not a ground issue cause other electrical stuff on the truck works to
The...
Ok I will give that a try. I'm not trying to be ingorant but whats the reason behind running a seperate power source? Isn't 12 volts 12 volts?. I will also check all the grounds. I don't think there will be an issue there cause I ran every ground wire back up to a common ground under the dash...
Hmm. I bacially started from scratch on the wireing. I used one power wire for all the exterior lights and just branched off of it for the brake switch and turn signal switch. Then I put the headlights on a relay. I used a common ground for all the lights to. I've doubled checked everything and...
Hi, I am currently in the process of rewireing a truck. The only factory pieces I'm reusing is the lights and the switches. I figured out what wires I need to use for the switches a ran all the wireing and I went to test it and everything worked as it should except the brake lights. All the...