Well guys I have already bought some of the stuff I thought I needed for this project like a
“Dc 4.5-30V 0-50A Dual LED Digital Volt meter Ammeter Voltage AMP Power Good ESY1”
a “RV24YN2OS Single Turn Carbon Rotary Taper Potentiometer” 5 pairs “Amplifier Terminal Connector Binding Post. & a 4...
Fish'
Thanks for the help. I am planning to use 2 AL. plates 1/32"- 1/16" X 1 Sq. Ft. each for cathodes. I could go a little bigger or smaller if need be. The parts will be anywhere from 1/2-1 Sq. Ft. From all the info I can find this can be done with a simple (dumb) battery charger but...
This power supply isn't for a computer. It's for anodizing aluminum parts. I took out the 250 w. supply from my computer & put a 600 w. supply in for gaming. What I need is a 12 VDC power supply to hookup to an acid bath that the parts will be hung in. It will have to be adjustable for amps so I...
Sorry. wish I could say that was the first time I've done that
http://www.wikihow.com/Build-Your-Own-Variable-Bench-Power-Supply-Using-an-ATX-Power-Supply
Here is the link. It's for an anodizing setup . From what I understand I will need about 12 VDC & 6-12 Amps depending on the size of the part & I need to keep the current steady. I think my power supply is rated at 400 w.
I'll go find it & check in a little while.
thanks
I am building a 12 VDC power supply out of a computer supply.
I got the info off wikihow.com
Here is a list of the parts that I have:
power meter
lm 317 voltage reg.
banana jack posts
5k potentiometer
.1 uF ceramic capacitor
1 uF capacitor
330 ohm resistor (1/4w) for power meter
120...