Haha! Thanks buddy! I know that already. What I don't know is, how to calculate the value of an amplitude threshold in clipped wave for which the resulting r.m.s value of voltage shall be 69.6 Volts (Approximately). If you could answer that would be really nice of you!
Here is a minor representation of what I have explained above. The figure explains only a clipped sine wave. For the bottom wave what must be the value of a0 (amplitude threshold) for which the output power across a 484Ohm resistance is 10W.
I am analyzing an AC signal of 220V rms and 60Hz frequency. I have to clip the wave from below, i.e. eliminating the negative cycle (using simple half-wave rectifier). Then I have to clip it from above as well. I have to clip it from above as well. Clipping from below was easy. But while...