Recent content by New2Electronics

Search Forums New Posts
  1. New2Electronics

    How is this Possible

    I understand the point. Please understand, I'm am learning so I won't have all the readily available info needed and I'm gathering as people request it. Thanks. I can appreciate not wanting to go through all those things. I understand. Thanks. I do NOT want to be shown the door. Unless of...
  2. New2Electronics

    How is this Possible

    Wow! I can see you take your moderator position as a license to be rude. When you asked for photos I did not have the ability at that time to post them. Why would that cause you to threaten to close this thread? Also pleading to others not to answer until I've complied with your demands. Is...
  3. New2Electronics

    How is this Possible

    I have resolved the problem thanks.
  4. New2Electronics

    How is this Possible

    I don't have a S CC HHH EEEE MMMMM AAAAAA TTTTTTT IIIIIIII CCCCCCCCC
  5. New2Electronics

    How is this Possible

    Unfortunately I don't have the capability to upload pictures at the moment. What particular info do you need? No-one has asked me any questions I haven't answered. Obviously there a more ways than one for this to happen. I'm looking for possibilities to explore and/or trying to understand...
  6. New2Electronics

    How is this Possible

    The cap is a cap. The diode looking component has a TS2 in print next to it. Does that help clear any cloudiness?
  7. New2Electronics

    How is this Possible

    Yes. The first thing I did was looked up the datasheet. According to the datasheet, at 115VAC into the transformer, with the current configuration, it should give 6VAC on the secondary side. I've got 120v going from my wall into the transformer so I guessed I'd get a little more on the...
  8. New2Electronics

    How is this Possible

    Hello. I have a DC power supply that takes 120vac into the transformer, steps it down to 8vac then puts that into the circuit using an LM 3 38 voltage reg. Other than a bridge rectifier, a few strange looking diodes and the usual cap and resistor there are no other components. How is it then...
  9. New2Electronics

    Drawing Amps

    Thank you
  10. New2Electronics

    Drawing Amps

    Am I understating this right? If my PSU has an output of 7VDC at 2A but my motor only draws 1A than the supply will only supply 1A? In other words as far as amperage goes I only use what is required within the specs of the transformer and circuit?
  11. New2Electronics

    Hook Up Wire for PSU

    What's the difference, conditions/wear and tear?
  12. New2Electronics

    Hook Up Wire for PSU

    Thank you
  13. New2Electronics

    Can You Paint a Circuit Board?

    Thank you guys!!
  14. New2Electronics

    Hook Up Wire for PSU

    Thanks. I'll look into that. No particular environment. Just out of my house.
  15. New2Electronics

    Hook Up Wire for PSU

    Am I to assume from your statement that all hook up wire available in the market is equal? ;) There's no "problem" with the wire I'm using at the moment, but I am wanting to learn about more options/better quality.
See more
Top