Recent content by nicko17

  1. N

    Reduce volts/Charge controller

    I wanted to charge my phone with the solar panel. The phone needs 5v and it can be on a usb cable. But this is such a pain to work with 6volts. I'm thinking i should just get more panels to work with 12volts. I dont have the solar panels yet so i dont know exactly what they will put out...
  2. N

    Reduce volts/Charge controller

    The charger plugs into the phone not the battery it self.
  3. N

    Reduce volts/Charge controller

    Alright that helps. The battery is NiMH high capacity. That will make a difference wont it for charging. I have car cell phone chargers , they say 12/24v input , 5v something output.. too bad i wont have 12volt input.
  4. N

    Reduce volts/Charge controller

    The reason i was using ebay cause it easy , and most of them have free shipping. Local stores ... i have no idea who sells this stuff. The sites you showed are very helpful. I may buy from digikey or element14 because of the cheaper shipping to Canada. I understand the LDO , what i need / how...
  5. N

    Reduce volts/Charge controller

    LDO , this one rated 1amp http://cgi.ebay.ca/ws/eBayISAPI.dll?ViewItem&item=320444169096&fromMakeTrack=true&ssPageName=VIP:watchlink:top:en I didnt find a shunt with enough amp rating. Maybe try somewhere else , any other good sites or stores i could look?
  6. N

    Reduce volts/Charge controller

    These be the right shunt regulators? http://cgi.ebay.ca/10PCS-TL431ACL-TL431-Precision-Shunt-Regulators-TO-92-/260546160727?pt=LH_DefaultDomain_0 and these for the LDO voltage regulator...
  7. N

    Reduce volts/Charge controller

    I charged the battery , it now reads 6.88Volts. The charger says on the plug it output 9v at 200mah I put the tester to it and i get 10.6V approx. What if my panel only put out 6 volts. And i need to use resistors with the shunt for it to get the right voltage?
  8. N

    Reduce volts/Charge controller

    Shunt regulators control how much voltage goes through the wires. But i dont understand how i can use that to control the charge. Lets say my float charge is 6volts , so i would just set the shunt to 6volts? I dont know much about the battery other than its 6v , i'm charging it now using the...
  9. N

    Reduce volts/Charge controller

    I'm making a small solar panel to experiment with it. It will put out around 6volts and 20 watts. I dont know much about electronics. Now i need a way to store the power generated , i will use a 6volt rc rechargeable battery. Is there an easy way i can control the charging of the battery so...
Top