Recent content by nikolaw

  1. N

    3-Axis Stepper Controller

    heloow i need step motors please help me
  2. N

    3-Axis Stepper Controller

    Where i can Bay online step motors? can you tall me some web pages????? thanks
  3. N

    3-Axis Stepper Controller

    Where are you from?
  4. N

    3-Axis Stepper Controller

    All is ok on board only one UCN5804 broke down and i replace that UCN whit another and everything i s ok bat what can burned UCN's i Use power pc suplly is this big supply? should i use 1. small power supply (i mean in A and V) 2. or use fuse 3.how mach is max volts and amperes of power supply...
  5. N

    3-Axis Stepper Controller

    I have a problem I build another Bord but one chip broke again i use http://www.doc.ic.ac.uk/~ih/doc/stepper/others/example2/ and PC power supply What is the problem  ??? ??? ??? :'( :'( :'( :'( How much Volts and Amperes i mast to use ??????? PLEASE HELP ME
  6. N

    3-Axis Stepper Controller

    how do u men i over heat the UCN chip?
  7. N

    3-Axis Stepper Controller

    my step drive dont work any more :( :( :( ucn is broken i bay new ucn' and thy broke too what is the problem :( :( :(
  8. N

    3-Axis Stepper Controller

    can you send me full schematic for something bigger thanks mp
  9. N

    3-Axis Stepper Controller

    HELOOOOOOW
  10. N

    3-Axis Stepper Controller

    WHERE I CAN FOUND schematic FOR MORE THAN 1,5 A FOR BIGER MOTORS THANKS
  11. N

    3-Axis Stepper Controller

    I use XP go in your BIOS (pres delete key wen your pc start ) and use &H378 in port setup
  12. N

    3-Axis Stepper Controller

    go in your bios and select 378 port in port setup i use wp
  13. N

    3-Axis Stepper Controller

    i use XP and u mas to do this go in port setup an do like the pic 2, 3, 4 - x-, y-, and z-axis step inputs, respectively. 6, 7, 8 - x-, y-, and z-axis direction inputs, respectively. Direction polarity depends on the motor connections. (to switch direction polarity, simply reverse the motor...
  14. N

    3-Axis Stepper Controller

    yes everthing works fine i made x , y mashine now i building z i will send soon u video of this mashine
  15. N

    3-Axis Stepper Controller

    can u send me some pic from your mashine??? this is the board , now i build mehanic :) thanks
See more
Top