Thank you, I seem to have another issue. After being told by the seller and looking at manual myself, i was told that terminals 10 and 11 were the correct terminals. I then, after looking at manual saw that terminal 10 and 2 are the 4-20ma output for the AR model which is a Analog/relay(AR)...
Yes, i just figured that out with the seller, he is sending the correct board.
Could you look at and comment on the SCR spec in the LINEARITY section, stating that it should have a maximum of 6.2 volts peak. At 19.5 to 19.9ma. Here is the picture from the manual. I believe the output of my...
My controller is puting out nothing. I have done nothing but hook these two devices together. The seller said they were tested together before he shipped them and they worked. I get them hook them up properly and nothing. I guess its my fault for not buying new.
How "rugged" is a 4 to 20ma output. I have done nothing that could have "injured" the output that I know of. I made all connections with power off (controller unplugged) the connections are super simple, + and -, the terminals were never in question. I just have no idea why there is nothing...
I have the heating elements all set up in my garage. I have spoken to a guy at Chromalox briefly, on my temp control, there is a light that comes on that tells you when the controller is applying signal to the SCR. That light is coming on. The guy i spoke to said if that light is coming on...
I am using terminal 10 and 11 on the temp control and 3 and 4 on the SCR. 10 and 3 being the positive and 11 and 4 being negative. Also here are some pics. of the SCR manual.
Hello all, this is my first post.
I am putting together a glass furnace. I bought some parts from someone on internet.( a Chromalox 2104 temp controller and a Watlow 80 amp SCR) When I purchased these, i told the guy "i knew nothing about electronics" " will these work for what I want to do"...