Recent content by russwr1

  1. russwr1

    How to increase high voltage from ignition coil using diode + inductor?

    Ignition coil (autotransformer with 3 terminals) output is not AC. It is a pulse forward. All voltage multipliers require AC input. You did not read the original question. I am practicing with high volts caps as pulse discharge into step up pulse transformer, trying to get 24kv from 6-15kv.
  2. russwr1

    Large Rectifier Pass Over Voltage In Reverse Bias ,- Not Fail Over Time?

    Can a large amperage stud diode as standard type low frequency, on series MILLIAMPS current, pass properly a much way higher over voltage in reverse direction , reverse bias, repeatedly as high frequency source, and not fail over time? I thought only overheating by large current failed diodes...
  3. russwr1

    How To Change Negative Volts To Useful Positive Voltage From A Pulse Discharge?

    Help wanted designing automatic circuit possibly with a separate switch, using directing diodes, blocking diodes, as zener or regular, for discharging negative charged capacitor OR Inductor coil, to resistor load with positive volts? Current passes through minimum initial 12v zener to charge...
  4. russwr1

    Leakage Inductance Useful??

    Is leakage Inductance Voltage Useful from 2 coils wound on same steel core? First is high volts in microamps with own circuit, 2nd is low volts with current in amps. The 2nd line needs over 100v. The first line doesn't short across, but passes normal volts in pulses down it's circuit and leaks...
  5. russwr1

    Mystery Wires Connection - Electromagnet from 2008

    What is this stranded copper wires thing sticking out from black electrical tape? Comments needed. I thought it was a THIRD wire going to resistor to ground to operate battery DC electromagnet, that was snipped off. A wire cut usually cuts through insulation + wire same time. A connection has to...
  6. russwr1

    Can electrolytic capacitor be increased in volts by using pulses in series?

    Can electrolytic 1uf capacitor be greatly increased in voltage, to over 100v, (like a boost converter), by half wave pulsing DC 35v going in SERIES through diode, l inductor coil, diode, l inductor coil, and diode to capacitor, without using DC resonant pulse charging? The off time allows for...
  7. russwr1

    Unusual Transformer Windings Ratio Problem. Tech comments Needed!

    The final water cell voltage from TR2 secondary was 30 volts pulsing DC. The zero was left off in the published Horvath patent.This was from positive type critical waveform due to the intentional laminations used, to get away from having to use a heat energy wasting large rectifier for 200amps. ...
  8. russwr1

    How to increase high voltage from ignition coil using diode + inductor?

    There was no diagram. The man from 2008 was using bench ignition tester box and said was able to get 40Kv from normal magneto coil of 6-15kv. He had inductor in line with spark gap inside the tester with range switch on 50kv. The triple wires coils was in plastic deli tub that acted as a...
  9. russwr1

    How to increase high voltage from ignition coil using diode + inductor?

    How to increase high voltage from ignition coil using diode + inductor Ignition coil is not AC output. Therefore a voltage doubler can't be used. Pulsing DC output high voltage, was reported in 2008 to have been increased using diode + Millihenry...
  10. russwr1

    Two Spark Gaps In Series?

    Great! Now one more thing,- It just seems to me, that If the positive high volts fires first gap as wide, and 2nd gap to ground is narrow, and in series, doesn't the final spark gap fire at same high voltage as first? The first gap has to fire to GET to the second gap to ground, and both points...
  11. russwr1

    Superposition circuits principal?

    Can a high internal resistance 9v battery be applied in parallel to 3vDC battery D cell amps pack to run a 10 amp 6V DC headlight bub at full brightness? Neither source power by itself can run bulb. Superimposed 2 sources to operate load bulb resistance? 9 volts DC added to separate power pack...
  12. russwr1

    Can ignition coil voltage be increased? How!

    Magneto fired ignition coil is not AC input, as being a single pulse transformer. It fires in milliseconds range. (not fast microseconds range of CDI) How to get the output increased in voltage?????? It is not AC output , and cannot use diode/capacitor multiplier like an AC transformer does. I...
  13. russwr1

    How to get higher, high voltage from ingition coil?

    Magneto fired ignition coil is not AC input, as being a single pulse transformer. It fires in milliseconds range. (not fast microseconds range of CDI) How to get the output increased in voltage?????? It is not AC output , and cannot use diode/capacitor multiplier like an AC transformer does. I...
  14. russwr1

    Dr. Clark Zapper pulsing DC Therapy information needed?

    The Dr. Clark pulsing on + off DC ZAPPER unit is an electrical therapy unit from the past, and is still being sold. The other- Tens unit, is not a therapy unit. It only reduces pain in patient for short period. As from reading information about Zapper, it seems the values of 30,000 cycles usage...
  15. russwr1

    Better Use For Capacitors

    Has any one investigated the use of quality capacitors as polypropylene types with very low ESR? The 2 Energy Conserver manuals published years ago by Eagle Research say that the capacitor is NOT an electrical load and is a storage vessel for electrons . A pre charged battery is unstable and...
See more
Top