Recent content by sinn

  1. sinn

    Thermister Controlled Fan??

    The engine will run too cool. It needs to stay between 240-260F for optimum operation. Thanks.
  2. sinn

    Thermister Controlled Fan??

    Hi, im looking to design a fan that kicks in when my engine reaches approx 260F, and switches off when the temperature is lowered to approx 240F. Are there any circuits that you guys know of?? I would be using a laptop fan of 5V / 0.16A. Thanks  ;D
  3. sinn

    Hey all. New member ere. Little help please??

    Yeah tried that. I was just curious if there was an electric method to minimise the heating effect from the two terminals (outside of engine). Thanks for your replies.
  4. sinn

    Hey all. New member ere. Little help please??

    Sure the pressure can be reduced, but it is almost impossible to calculate the absolute perfect pressure that will cause the plug to start glowing. I am using more powerful fuel for big gains in performance. It's a little project. I was hoping there'd be a more simpler electronic method to...
  5. sinn

    Hey all. New member ere. Little help please??

    Apologies dude. New to the forums ::)
  6. sinn

    Hey all. New member ere. Little help please??

    Hey, apologies for not going into much detail. Yes it is a glow engine. The principles of the glow engine is as follows: "as the piston reaches the top of the cyclinder, the huge increase in pressures makes the nickel wire glow red hot. This glowing nickel wire ignites the fuel mixture". My...
  7. sinn

    Hey all. New member ere. Little help please??

    Hi Ante, well the coil must be heating (glowing) since it is igniting the fuel mixture. I have checked for potential difference between the two ends, but were're talking very very small voltages (microvolts). It's probably a silly question, but if I linked the two ends, wouldn't the wire stop...
  8. sinn

    How could I stop a nickel coil from emitting IR?

    Hi, first of all, i'd like to say it's been an interesting read of the forum topics. I'd like help on something. I have a nickel coil, that glows hot due to high pressures within an internal combustion engine. The two ends of the coil aren't linked to anything; the coil only glows because the...
  9. sinn

    Hey all. New member ere. A little help please??

    Hi, first of all, i'd like to say it's been an interesting read of the forum topics. I'd like help on something. I have a nickel coil, that glows hot due to high pressures within an internal combustion engine. The two ends of the coil aren't linked to anything; the coil only glows because the...
  10. sinn

    Hey all. New member ere. Little help please??

    Hi, first of all, i'd like to say it's been an interesting read of the forum topics. I'd like help on something. I have a nickel coil, that glows hot due to high pressures within an internal combustion engine. The two ends of the coil aren't linked to anything; the coil only glows because the...
See more
Top