Recent content by sparky666

  1. S

    0-30V Stabilized Power Supply

    I forgot to mention that I connected a light bulb from a car which had approx.  1ohm resistance, and the project was working normally(min voltage 0.0V, max voltage 30.0V and max load 3A), so I'm totally out of guesses what is wrong...
  2. S

    0-30V Stabilized Power Supply

    I measured the voltage of the project with a 10k resistor since that resistor was in hand, and the min voltage was 1.1V and the max was 30V, without it, it the min was 6.4V and the max 30V;with the output shorted,the min was 0.0V, but the max was 0.3V. And the two 2n3055 transistors that I use...
  3. S

    0-30V Stabilized Power Supply

    Audioguru! I made the measurements as you said. With the voltage pot set to 0, and the current pot at max, the output voltage of the project is 6.1-6.2V, the voltages at U1 : pin1,4,5 0V, pin2 1.9V, pin3 -0.5V, pin6 0.01V, pin7 36V. The voltages at U2:  pin1,2,3,4 0V, pin6 0.01V, pin7 36V. The...
  4. S

    0-30V Stabilized Power Supply

    Hi again! The supply is the latest version with mc34071. The voltage at U3's pin4 is -1.5V. In my region, we call heli pot a potentiometer with multiple turns(12 turns for me).
  5. S

    0-30V Stabilized Power Supply

    Hi guys! I have recently built the supply, but I have two major problems: Firstly I could set the upper limit of the voltage to 30 V, but the lower limit stays at 5.6V no mater what I do, and at this voltage the LED is on, and if I switch to the max current limit, then the voltage jumps from 5.6...
  6. S

    0-30V Stabilized Power Supply

    I would like to build this power supply too. Now I'm making the PCB design for bottom layer only PCB, when I saw that something's wrong with U1(I think).  The Vcc+ pin is at the In- side, and the Vcc- at the In+ side. How is that IC placed there? And one more thing: Can I use TL071CP instead of...
See more
Top