Recent content by userqq

  1. U

    Powering 2 Devices from 1 Adapter

    When you think about it, it should work because in a car the battery is powering differrent things at once. I think the main danger here is that if you happen to accidentally overpower one of the devices then maybe it could get burned out.
  2. U

    Battery powered wireless microphone

    seems to me like the 18v cordless drill battery would have too much current.
  3. U

    Garage Door Remote! (HELP!)

    I think its cheaper to get a whole new system but try ebay and look for a good deal.
  4. U

    simple current question

    PCM Connection Hi, As you know I had to replace the li-ion battery in a portable device. I have the unprotected battery and proper PCM (protection circuit module). The PCM wiring is pretty straightforward as you can see by the pics. I have Battery + and - and power (load)+ and - but there is...
  5. U

    simple current question

    OK ins co finally paid for my meds! so im back. CocaCola the dimensions are kind of hard since the space is trapazoidal but basically I have 3.2 X 5 cm, Im looking at 3 unprotected 10440s with this http://www.ebay.com/itm/350608175291?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649 PCM...
  6. U

    simple current question

    sorry guys, I did not mention that I am sick and its now a bad time. I'll have to get back to this hopefully sometime next week.
  7. U

    simple current question

    sure, gas detector. still unsure about any difference in charging single protected batteries and 'a bank' of 2 or 3 protected by one circuit. I hate being uncertain like this.The parts will take a long time to get here from HK so I need to make a decision soon. Im starting to think that it...
  8. U

    simple current question

    Thanks guys, I am about to order the batteries from manafont. My choices are 3 individually protected batteries (easier, guaranteed fit) or 3 unprotected batteries (same specs) in parallel all connected to ONE PCM (pictured below) Note:as you can see below the original battery (NG) was one (i...
  9. U

    simple current question

    Thanks for the answer Bob and yes you are right I had not checked the actual voltages I just needed to know the physics of it and I thank you for that info:) So now I have another question. Lets say that I take 3 (three) 3.7 v 600mah batteries and connect them in parallel will I then have 3.7 v...
  10. U

    simple current question

    Hi, If I put 3 (three)1.2 volt, 600 mah li ion batteries in series will I have 3.6v 1800mah or 3.6v 600 mah? thanks in advance
See more
Top