Search results

  1. Mikromike

    3-Axis Stepper Controller

    RobiD, Are you using a new Dremel or a old one. Also recheck for loose wire connections. I had the very same problem it turned out to be a loose wire that was only affected from the vibration. Mike
  2. Mikromike

    3-Axis Stepper Controller

    Another ;D
  3. Mikromike

    3-Axis Stepper Controller

    OK I'll try it again.
  4. Mikromike

    3-Axis Stepper Controller

    Here are some pics. ;D
  5. Mikromike

    3-Axis Stepper Controller

    Thanks MP, All is working now. I found in KCam where you can change pin setting so I configured the port pins and now, like magic it works. ;D
  6. Mikromike

    3-Axis Stepper Controller

    Hello All, I finally connected my new board to the computer after testing it with a 555 chip and the motor stepped like it was suppose to but now that it is connected the computer it will not step. I noticed that the input ports are either high or low but shouldn
  7. Mikromike

    3-Axis Stepper Controller

    Thanks for the advice MP...Mikromike
  8. Mikromike

    3-Axis Stepper Controller

    Thanks MP, you brought something to my attention though. The schematic shows C1 = 0.01uF, C2 = 10uF Polarized, and C3 = 0.01uF but the board parts lay-out shows C1 as being polarized. I hope this is NOT a problem, I laid my board out just like the parts lay-out shows, it seems to work. I hooked...
  9. Mikromike

    3-Axis Stepper Controller

    Hello: I starting to build this 3 Axis controller and was wondering if it
Top