Search results

  1. C

    Yamaha RX-V373 In protection

    Hello, I've made some progress. I have put the new STK in and replaced the 0.22 resistor but have encountered another problem. I now shuts off on protection from PS PRT 043L. I can get into no protect mode and I hear the relays put in. The voltage on PS_PRT where it connections on the operation...
  2. C

    Yamaha RX-V373 In protection

    Alright, thank you so much for your help. I will get these two parts and post how it goes. (shipping probably take 4 weeks to NZ haha) Yes, I've seen people doing that so ill do that too. Thank you.
  3. C

    Yamaha RX-V373 In protection

    Thank you so much, that was so helpful and I think you have nailed it. I have measured all of these now I believe. I actually don't think there is any visible burn on the resistor but you were absolutely right about being just the "burnt" part having high resistance. I think it looks burnt...
  4. C

    Yamaha RX-V373 In protection

    The one closest to the edge of board is the one im thinking about.
  5. C

    Yamaha RX-V373 In protection

    Hello, thanks for the reply. I think it is R48 and has 3 legs, yes, I think it says 3W, 2-0.22ohms it is quite hard to ready. The others that seem to be the same all match each other with 0.2ohms to middle leg and 0.4ohms end to end. Just this one which is the odd one out. Oh right just seen...
  6. C

    Yamaha RX-V373 In protection

    Hello, I have a RX-V373 receiver which I believe is turning off in protection. This unit was working perfectly but wasn't used for a few months, and recently when I went to turn it on nothing happened. I believe it is stuck in protection because when I hold tone control + straight the unit...
Top