Search results

Search Forums New Posts
  1. G

    Altium Designer Rigid-Flex Manager question

    Looks like a good starting point. I’d confirm the stackup with your PCB manufacturer, especially the flex materials, coverlay, and stiffener. The surface finish is usually specified separately by the manufacturer rather than as a stackup layer.
  2. G

    5013 - Component identification

    The 5 V input and 3.2 V output help, but pin 4 IN and pin 9 OUT alone probably aren’t enough to identify the exact part. If you can post a close-up of the marking on the component, that would be the best clue. A photo of the surrounding circuit would also help, especially the pins connected to...
  3. G

    Anyone identify this connector?

    It looks like a 51-pin FPC/FFC LCD connector with the locking bar missing. Panasonic lists a 51-pin connector (K1MY51BA0667) for the LX100, so that may be the relevant part. I’d compare the pitch and contact orientation before replacing it. The LCD ribbon connection is documented in the LX100...
  4. G

    PCB Manufacturing — Complete Beginner’s Guide

    Hi, for a beginner I had keep it pretty simple. For PCB manufacturing, you will normally send the Gerber files to the manufacturer. If you also want them to assemble the board, you will usually need the BOM and pick-and-place file as well. Single-layer boards are mainly for simple circuits...
Top