Search results

  1. C

    Modding a lamp

    I see, I won't need the audio again, so how will I turn it off then?
  2. C

    Modding a lamp

    thanks.
  3. C

    Modding a lamp

    why do i need that transistor tho? i dont want audio.
  4. C

    Modding a lamp

    I don't have a multimeter, maybe you know approximately? I already have 27/30/33/1k resistors, maybe one of them?
  5. C

    Modding a lamp

    sorry for the scare ) here is the pic
  6. C

    Modding a lamp

    hello, i have this lamp i wanted to remove the audio from, so i just unsoldered the speaker, & it worked, is this fine? or do i need to add a resistor? it uses 3 AA batteries, here is a video of the lamp. www.aliexpress.com/item/1005004770875002.html
  7. C

    Modding a lamp

    i think the iron is bad, at 320 it doesnt melts, i just put it on max temp 520, & use the sides, couse the tip isnt good, also there is smoke when touching the metal, its the cheapest on aliexpress ) but its ok im somehow doing it ) thanks for the help!!
  8. C

    Modding a lamp

    thanks!
  9. C

    Modding a lamp

    ok thanks!
  10. C

    Modding a lamp

    btw i tried the led without a resistor at all for couple of seconds, it didnt blew, it was brighter tho, less brighter with the 30 ohm resistor.
  11. C

    Modding a lamp

    so what resistor should i use for one led?
  12. C

    Modding a lamp

    you told me to use 30 ohm resistor for the two leds, Assuming 2.1 Vf. the batteries are 3 AA 1.5v each, & I just removed 1 led. what do you mean by drawing? its just 1 led batteries & a switch, you need a pic?
  13. C

    Modding a lamp

    ye I've checked it, I think its burnt, so if I remove one of the leds then the resistor should stay the same one, right?
  14. C

    Modding a lamp

    i did it, but one of the leds doesnt works, if I remove one of the leds then the resistor should stay the same one, right?
  15. C

    Modding a lamp

    hey, i tried to do your method but it didnt worked, i think my soldering skills are bad ) or the soldering iron is bad, anyway ill see what ill do next, thanks anyway!
  16. C

    Modding a lamp

    hey, i tried to do your method but i think the components on the circuit are too small, so i decided doing hes method, but it didnt worked, i think my soldering skills are bad :) also i wanted to check the tweeter for you but it was too late, i cut some wires already, going to think what to do...
  17. C

    Which led wire is positive?

    thanks!
  18. C

    Which led wire is positive?

    what does it means? the left pad in each square is negative?
  19. C

    Which led wire is positive?

    the two red squares are two led's, each have two wires, Which wire is positive in each square?
  20. C

    Modding a lamp

    this pic
Top