Radionics D5200 Programmer

[T.J.]

Does anybody know a good place where I can buy a D5200 Programmer
and about how much it would cost? Thanks!

 

[Crash Gordon]

Jim Rojas probably has a few.
I have two but I can't part with them.

--




| Does anybody know a good place where I can buy a D5200 Programmer
| and about how much it would cost? Thanks!
|

 

[Crash Gordon]

They still sell them? I had both mine refurbished 5 years ago didn't think
they still supported them.

--

Rob Giordano
Microsoft MVP - FrontPage





| Radionics/Bosch sells them and they run about $800, also try Ebay, they
| currently have one at auction
|
| | > Does anybody know a good place where I can buy a D5200 Programmer
| > and about how much it would cost? Thanks!
| >
|
|

 

[Crash Gordon]

Troo.


--

Rob Giordano
Microsoft MVP - FrontPage





| Data lock will prevent both programmer and downloader from getting in but
a
| 5200 gets around an unknown RAM passcode
|
| | > The wrong data lock or RAM pass code can end the programming instantly.
| >
| > | > >
| > > | > >> What panels are you trying to program? If you have a laptop I'd spend
| the
| > >> money on RPS software and a 4010i instead of a 5200. It is a real
pain
| to
| > >> program a panel with a 5200 versus RPS software.
| > >
| > > Unless someone changed the RAM access code, then a 5200 is your only
| hope
| > >
| > >
| >
| >
|
|

 

[Silicon Sam]

What panels are you trying to program? If you have a laptop I'd spend the
money on RPS software and a 4010i instead of a 5200. It is a real pain to
program a panel with a 5200 versus RPS software.

I have RPS on my laptop (not sure which version, 2.something) and
have an Enhanced Direct Connect module I used on 7412 and 9412 panels
a while back. What do I need to buy to be able to program and connect
to the newer Bosch panels they sell? I haven't done any burg panels
in quite a while, I've been doing nothing but access panels and CCTV
lately.

Raymond

 

[Silicon Sam]

RPS is up to version 5.5 I believe. If you are programming only G series
panels (D7212G, D7212GV2, D7412G, D7412GV2, D9412G, D9412GV2) you need the
software, the software dongle, a DX4010i, or a DX4020 for local connection
or a SecurComm or a StarComm modem for remote connection.

I have the software and dongle. And I've been to a 7412G/9412G
class a few years ago. Guess I need to try find either a modem or the
local connection module then. I wanna say we've sold a few 6412
panels lately. Same direct connect module then?