Solenoid controlled valve

[[email protected]]

I have an injection molding machine with the following faulty solenoid
controlled valve and I wanted to know if it can be replaced with a
better quality/better brand component:

Daikin industries, ltd
Solenoid Controlled Valve
Mod No: KSO-G02-2CP-10
MFG No: 1380

It is a 2 way solenoid controlled valve with magnetic coil 24 VDC.

Any guidance would be appreciated

 

[Spehro Pefhany]

I have an injection molding machine with the following faulty solenoid
controlled valve and I wanted to know if it can be replaced with a
better quality/better brand component:

Daikin industries, ltd
Solenoid Controlled Valve
Mod No: KSO-G02-2CP-10
MFG No: 1380

It is a 2 way solenoid controlled valve with magnetic coil 24 VDC.

Any guidance would be appreciated

Assuming you're in Europe, you might want to contact Sauer Bibus in
Neu-Ulm [email protected] (49) 731-1896-0

This should be the data for your solenoid hydraulic valve:
http://www.sauerbibus.de/pdf/J-KSO_G02_005_1103.pdf



Best regards,
Spehro Pefhany

 

[[email protected]]

Dear Spehro,

Thank you for your guidance. The PDF file shows 2 nozzels at the top (A
and B), however the the daikin model that I have only has one nozzel.
Is that ok?

Just out of interest, quality wise, is "Sauer Bibus" the best available
in the market?

Thank you,

 

[[email protected]]

Dear Spehro,

Thank you for your guidance. The PDF file shows 2 nozzels at the top (A
and B), however the the daikin model that I have only has one nozzel.
Is that ok?

Just out of interest, quality wise, is "Sauer Bibus" the best available
in the market?

Thank you,

 

[Terry]

I have an injection molding machine with the following faulty solenoid
controlled valve and I wanted to know if it can be replaced with a
better quality/better brand component:

Daikin industries, ltd
Solenoid Controlled Valve
Mod No: KSO-G02-2CP-10
MFG No: 1380

It is a 2 way solenoid controlled valve with magnetic coil 24 VDC.

Any guidance would be appreciated

What voltage controls the existing valve?
If it is the same voltage and the relay timing and speed of operation are
correct it 'should' work.
If not you are redesigning the machine.