Latest activity
-
DDOC ANDY replied to the thread high voltage electrolytica capacitor vs oil filled.i THINK SO THOUGH IT LOOKED ROUND NOT SQUARE SHAPED i WILL TAKE A PICTURE AND SEND IT TO MORROW
-
Hello. Is there anyone here that can show me an impedance-versus-frequency plot for any television reception antenna of any manufacturer ? -
DDOC ANDY replied to the thread high voltage electrolytica capacitor vs oil filled.Thanks for your reply The damaged part has lost the identifying marks Its purpose was to store energy, almost square waveform "Edmark...
-
Ttom1970 replied to the thread Amplifier biased too hot?.BTW some people are suggesting that it is ok to leave a trim pot in the RX position rather than have it as a temporary component. Is...
-
Ttom1970 replied to the thread Amplifier biased too hot?.Thanks so much for the very thorough reply. I followed the procedure and it is pretty much sorted. Just need to tune one side a little...
-
THave had a look at the supplied schematic. To adjust the output idle current, use the following procedure. Referring to the amplifier...
-
Dcan´t find a 6KV 28 uF electrolytic cap(perhaps a toothed hen will be easier),but I have several NOS oil filled of similar value...
-
Have had a look at the supplied schematic. To adjust the output idle current, use the following procedure. Referring to the amplifier... -
WHONOES replied to the thread Amplifier biased too hot?.Have had a look at the supplied schematic. To adjust the output idle current, use the following procedure. Referring to the amplifier... -
-
-
-
Fursday Funny
-
davenn replied to the thread Comedy Thread.
-
-
THi everyone, Been a while since I last posted. Hope you are all well. I've just repaired a NAD 3130 stereo amplifier which had a blown...
