Latest activity
-
davenn reacted to Martaine2005's post in the thread Changing USB Powered Security Cameras to AC 120 with
Like.
Yes of course. The easiest solution is to use a 120VAC to 5VDC step down power supply. The cameras should have a label with power... -
CCrafts4Me replied to the thread revolving chandelier with a way to plug in led strips.hi i am still trying to do this and not succeeding my hut is a sukkah. i do all the decorations on my own. i made a new crown, it weighs...
-
hevans1944 replied to the thread Suggest device for logging AC current?.A Mooshimeter will provide a Bluetooth wireless cell phone display. Just had a clamp-on AC current probe. -
hevans1944 replied to the thread Changing USB Powered Security Cameras to AC 120.Please report back how you solved your problem. I, too, have motion-detecting outdoor flood lights and a couple of Wyse "cube cams" that...
-
hevans1944 reacted to Martaine2005's post in the thread Changing USB Powered Security Cameras to AC 120 with Like.
Yes of course. The easiest solution is to use a 120VAC to 5VDC step down power supply. The cameras should have a label with power...
-
hevans1944 replied to the thread Wanted: MOTRONIC DIGITAL DC MOTION CONTROLLER / SOFT STARTER.It appears, as we say here in the States, that you are SOL on your quest. I asked Grok 4.5 for help and copied its reply below. I also...
-
hevans1944 replied to the thread I Was Lost, But Have Been Found Again.I "bookmarked" ElectronicsPoint.com a few years ago. Still seems to work, but I don't visit here much anymore...
-
MManutr83 posted the thread Wanted: MOTRONIC DIGITAL DC MOTION CONTROLLER / SOFT STARTER in For Sale / Wanted.Hi, I am looking for Motronic DC Motion Controller/Soft Starter, Model SS-1. Can anybody advice where I can find this
-
-
Ddanadak replied to the thread Dealing with limited GPIOs on ESP8266 vs upgrading to ESP32 for IoT security?.I am a newbee to RTOS to handle dual cores, but the first experience, simple as it was, made a dramatic difference in code...
-
Martaine2005 replied to the thread Changing USB Powered Security Cameras to AC 120.Yes of course. The easiest solution is to use a 120VAC to 5VDC step down power supply. The cameras should have a label with power... -
baldguyfromblackpool posted the thread Suggest device for logging AC current? in General Electronics Discussion.I have a Zappi EV charger which is working fine when I plug my BYD car into it, but when Mrs Baldguy plugs her MG into it, all sorts of... -
CChris Johnston posted the thread Changing USB Powered Security Cameras to AC 120 in General Electronics Discussion.I have video cameras that run on USB power, but the factory USB cable is much longer than I need. The Lorex cameras I’m using have...
-
hevans1944 replied to the thread RF-ID advice needed.@collectors: What is your experience with electronics? Are you looking for a plug-and-play commercial off-the-shelf (COTS) solution? Or...
-
Delta Prime reacted to Audioguru's post in the thread AEC Chaser only lights first LED. Newbie needs help with Like.
When a 555 IC is used as an oscillator then the minimum resistor value for the resistor from pin 7 to the positive supply is 1k ohms... -
CHi Bob, If you are still active, I have seen your post of 2011, and would like top make contact. My name is Cliff Richards and I was in...
