Delta Prime's latest activity
-
Delta Prime reacted to Martaine2005's post in the thread Recommended ways to program Uno board with
Like.
You don’t generate its code, you write it. C or C++. But there are 10s of thousands already written on sites like Arduino or github... -
27.145 MHz is channel 4 or YELLOW for RC cars, boats etc. It’s now old technology. But to answer your question, it’s definitely possible...
-
If this is the right connector and only the locking bar is missing, you may try to get a replacement connector and transplant the...
-
Delta Prime reacted to Audioguru's post in the thread AEC Chaser only lights first LED. Newbie needs help with Like.
When a 555 IC is used as an oscillator then the minimum resistor value for the resistor from pin 7 to the positive supply is 1k ohms...
-
Delta Prime replied to the thread Suitable replacement for a large Siemens capacitor in an old IBM XT power supply.The printed nominal capacitance value, is not the actual value capacitance and will vary depending on circuit frequency. As long as...
-
Delta Prime replied to the thread Found problem in Kenwood KR-V95R.Replace with two 6800 microfarad capacitors connected in series which will cut the capacitance value in half and will equal 3400uf.
-
Delta Prime reacted to bidrohini's post in the thread JK Flip-Flop Toggles Twice from One Button Press with Like.
This sounds very much like switch bounce reaching the clock input. A JK flip-flop will respond to clock edges, so if the button produces...
-
Delta Prime reacted to Martaine2005's post in the thread Help diagnosing AC Sliding gate controller stops halfway with Like.
Upon further reading, your units limit switch looks to be similar to this, so the set up would be very similar too. Make sure the...
-
Delta Prime reacted to 73's de Edd's post in the thread Help diagnosing Trinitron KV-32FV27 with Like.
Sir Coolsuggies . . . . . Consulting ye olde Sunny Service manual . . . . . on their page # 41. You need to check out the "C " board...
-
Hi, A dog. C
-
Your circuit will not work in 99.9 %, unless some intelligent programming is used for the ports (see below: risk of short circuit)...
-
Delta Prime reacted to crutschow's post in the thread Latching relays in a control circuit with Like.
My question was whether you could wire and solder the parts on a vector board if given the circuit schematic and the parts required?
-
I would recomend the Vero strip board, there is a free design/layout pgm VeeCAD.
-
pulse streams of desired width and inter pulse delay. Pulses are outputs to a pin to initiate an action like turn on a fan or light. So...